Text only | Text with Images

VEMS Community Forum

Technical => Wiring & Sensors => Topic started by: rossi46numberone on August 04, 2011, 01:51:17 AM

Title: question about grounding RS232
Post by: rossi46numberone on August 04, 2011, 01:51:17 AM
Hi,
I have read in an other topic that the EC18-pin 17 is internally grounding for convenience.
Does this output can be use for grounding the RS232;or is better to go EC36-pin 26?

Michele....
Title: Re: question about grounding RS232
Post by: gunni on August 04, 2011, 08:47:36 PM
measure if it connects to EC36-25 the sensor ground, if so then its fine
Title: Re: question about grounding RS232
Post by: mattias on August 08, 2011, 11:40:51 AM
If you have a knock chip, but not using it, then you can use the knock signal ground as RS-232 (serial port) ground.
Title: Re: question about grounding RS232
Post by: boostd audi on August 09, 2011, 04:07:27 PM
it should ground to pin 26 not 25  ;)

typo
Text only | Text with Images