Print Page - Wheelspeed sensor?

Title: Wheelspeed sensor?
Post by: ktm_micke on March 18, 2011, 11:05:08 AM

Hi
Is it possible to connect a wheelspeed sensor to the keyboard input on VEMS box.
The box is ordered with PS2 keyboard option but in Vemstune there is no menu (speed sensor) at Base Setup for calibrating it.
FW is 1.1.81
But if I open a base configfile 1.1.88 there is this menu.
What to do?
//Micke K

Title: Re: Wheelspeed sensor?
Post by: mattias on March 18, 2011, 12:38:55 PM

http://www.vems.hu/wiki/index.php?page=InputTrigger%2FWheelSpeed

http://www.vems.hu/wiki/index.php?page=GenBoard%2FUnderDevelopment%2FFirmwareChanges

http://shop.vems.hu/catalog/wheelspeed-cable-p-143.html

Title: Re: Wheelspeed sensor?
Post by: ktm_micke on March 18, 2011, 01:01:24 PM

OK if I understod right I must select non PS2 FW in the menu "Tools/Firmware/Firmware upload" when I upload new FW.
To get the option for calibrating speed sensor.
Am I right?
//Micke K

Title: Re: Wheelspeed sensor?
Post by: mattias on March 18, 2011, 01:10:49 PM

Yes, use non-PS2.

Title: Re: Wheelspeed sensor?
Post by: JRD McLAREN on November 08, 2012, 12:53:20 PM

So ..I have another one stupid question about it..

Is there anybody, who have worked VSS with 12V HALL sensor ..??

Now I have small board with 2x2k7 resistor zener diode and 100n cap, like this http://www.vems.hu/wiki/index.php?page=InputTrigger/WheelSpeed

But I can't find anybody, who will assure me, YES IT WORK ON 12V HALL or, don't do this, you will be damage your processor

Title: Re: Wheelspeed sensor?
Post by: JRD McLAREN on December 25, 2012, 06:36:46 PM

so the answer is ..
Yes it works...

VEMS Community Forum

Technical => Wiring & Sensors => Topic started by: ktm_micke on March 18, 2011, 11:05:08 AM