at idle the EGO correction is 75%,in simple words what does it mean??
and which table do I have to modify to reach 100%...
Any suggestions??
Regads,Michele.
Quote from: rossi46numberone on February 24, 2011, 05:33:02 PM
at idle the EGO correction is 75%,in simple words what does it mean??
and which table do I have to modify to reach 100%...
Any suggestions??
Regads,Michele.
Hi!
It means the Ego is cutting of 25% fuel in order to make lambda match the current lambdatarget.
Lower your VE-Table is that area and you will notice what happens to the Ego Correction percentage.
but when you say the "VE-table" are you talking about the fuel table?
If yes ,i can't do this because the cell value is "2"and I can't go down :'(...
And if I decrease this value to "1" the engine run bad.
where is the mistake.... ???
Michele.
Quote from: rossi46numberone on February 24, 2011, 06:28:49 PM
but when you say the "VE-table" are you talking about the fuel table?
If yes ,i can't do this because the cell value is "2"and I can't go down :'(...
And if I decrease this value to "1" the engine run bad.
where is the mistake.... ???
Michele.
Yes, VE-Table = Fuel-Table.
My guess is that you have an sky-high Requiredfuel-value?
Try lower it to 1/5 of your current value and raise your whole VE-Table by 4 or 5 times.
Please post a .vemslog or .vemscfg !
Let's continue in the other thread.
http://www.vemssupport.com/forum/index.php/topic,1603.0
This thread is locked.