Print Page - VEMSTune from Celsius to Fahrenheit

Title: VEMSTune from Celsius to Fahrenheit
Post by: amd is the best on February 02, 2011, 09:38:23 PM

Hey Guys,

New here and new to VEMS but not new to standalone EMS/tuning. I am ordering up a VEMS unit from Marc at EFIExpress for my 1991 Audi 200 20v (3B) and have been playing with the software (VEMSTune) a bit to familiarize myself with it. I can't seem to figure out an easy way to switch the entire software over from Celsius to Fahrenheit. Is this possible?

Thanks in advance,
Nick

Title: Re: VEMSTune from Celsius to Fahrenheit
Post by: Jim_W on February 03, 2011, 10:57:55 PM

In VemsTune:
File -> Firmware Parameters -> set "CELCIUS" to 0 (zero). Not exactly where you would think to find it.

Title: Re: VEMSTune from Celsius to Fahrenheit
Post by: amd is the best on February 03, 2011, 11:10:35 PM

Thank you for the response. That didn't seem to change anything over though, even after the recommended restart.

VEMS Community Forum

VEMS => Software => Topic started by: amd is the best on February 02, 2011, 09:38:23 PM