Has anyone configured vr6 with camsync? I tried with 1.0.73 raw 24 with no success, falling and rising edge... Without camsync runs just fine, but when I enable cs, no rpm in megatune.
Regards
Anyone?
Have you thought about updating the firmware and then checking the trigger log?
do you have one tooth on the secondary trigger?
I'll update fw tonight, and try to figure out what's going on with trigger. Yes, there's one tooth on sectrig. I haven't much time to play with it these days, but tonight its science night again :) Thanks!
I tried with 1.1.85, and recorded trigger log. No sign of sec trigg in log. Doublechecked wiring for broken wires, and there was none. Checked HAL with LED, it seems to be okay. Science night continues... :)
Finally Corrado got secondary trigger. I removed resistor that was where blue rectangle is. Strange thing is I didn't order genboards with Auditrigger, only two genboards from webshop, without any options, and got one "normal", and one with two lm1815's, and 2k7 resistor on sec trigger for auditrigger.
(http://www.dodaj.rs/t/13/4F/4VTcFIgp/v36sectrigger1m.jpg) (http://www.dodaj.rs/?13/4F/4VTcFIgp/v36sectrigger1m.jpg)