Text only | Text with Images

VEMS Community Forum

Technical => Wiring & Sensors => Topic started by: krzycho-g on August 27, 2010, 06:37:11 PM

Title: VEMS support LSU 4.9 (4-93)?
Post by: krzycho-g on August 27, 2010, 06:37:11 PM
Hello

I'm ask, because i had LSU 4.2 in my car and all its ok. Now installed LSU 4.9 , calibrated, run engine , after 10 second i have not read and can no longer calibrating this sensor
I've just damaged the second  :'(

Kris
Title: Re: VEMS support LSU 4.9 (4-93)?
Post by: gunni on August 27, 2010, 09:32:20 PM
Why did you install a 4.9 sensor without checking first?
Title: Re: VEMS support LSU 4.9 (4-93)?
Post by: lugnuts on August 27, 2010, 10:49:36 PM
Speaking of....  would it be possible to use an NTK sensor with the VEMS hardware as-is?
Title: Re: VEMS support LSU 4.9 (4-93)?
Post by: krzycho-g on August 28, 2010, 05:48:06 AM
just i dont know.. ;D
and my 200 $ bye bye  :'(

that is not possible, right ?
Title: Re: VEMS support LSU 4.9 (4-93)?
Post by: paul_f on August 29, 2010, 02:02:26 PM
Quote from: lugnuts on August 27, 2010, 10:49:36 PM
Speaking of....  would it be possible to use an NTK sensor with the VEMS hardware as-is?

I was told you could

http://www.vems.hu/wiki/index.php?page=MembersPage%2FPaulF%2FEFIComponents

I haven't tried it yet though, the sensor is still sitting in the box!  I couldn't find the pinout of the sensor I had and so took the easy option of getting the Bosch sensor
Text only | Text with Images