Good day to all of you guys... Recently a friend bought a Citroen Saxo turbo running a dp-engineering PNP ECU... I know at some point this was a topic in here as I have searched the forum....I have emailed dp-engineering and there was no response yet...(8 days and counting)....The car was in version 1.0.72 which was not in the web library... I updated the firmware 1.0.75 so I could use VEMStune... Now for my questions: If I update to 1.19. something before the new bootloader will I need to check my harness pinout??? The second question: Do I need to use an AVR ISP cable to flash the new boot loader and go to the newer firmware... educated guess the ECU is dated before 2010... As I saw the newer firmware is much much better from what I saw... and my final request if someone can share the stock sensors calibrations for the TU5J4 1.6 motor...
Best Regards and many thanks
George
hi, probably you would need isp cable and probably you will need to write email to vems requesting bootloader upgrade
Morning did you have any success updating to he newer firmware ?