Text only | Text with Images

VEMS Community Forum

VEMS => Software => Topic started by: Turbos10 on April 05, 2010, 07:48:16 AM

Title: Error in Windows when trying to open Megatune
Post by: Turbos10 on April 05, 2010, 07:48:16 AM
All,

I am trying to open Megatune and continue to get an error in windows that just says "megatune efi tuning has encountered a problem and must close".  It will not open at all.  PC has windows XP.

Anyone help with this??

Thanks!
Title: Re: Error in Windows when trying to open Megatune
Post by: gunni on April 05, 2010, 07:40:47 PM
What version are you trying to open?

Maybe try re installing that version?
Title: Re: Error in Windows when trying to open Megatune
Post by: [email protected] on April 05, 2010, 10:40:04 PM
If you are starting with a fresh install you may be better off using VEMSTune
Title: Re: Error in Windows when trying to open Megatune
Post by: dnb on April 07, 2010, 03:57:26 AM
This is usually because you have the AIM dash output via the serial port on the ECU enabled. 

If you connect the VEMS to the laptop, load MT and then power up the ECU it should work and you can disable AIM.  It should all be fine then.
Text only | Text with Images