I have a simple question.
My ABZ v8 engine for instance has a 15amp fuse for the injectors. In the vems manual it has a 10 amp fuse setup. Should I be using the OEM rating or the vems rating for fuses?
The stock ignition has a 20amp rating and the vems manual says 10amps. I'm thinking i should use the OEM sized fuses for this application correct?
Sorry for such a newbie question.
I'm asking this because most likely I'm going to use circuit breakers instead and make a custom box for it. That and the fact I do like to know an answer.
(http://www.defender.com/images/201684.jpg)
thanks
josh
I´m sure your oem injectors are all jointly using the same fuse and some other parts as well.
Same for the ignition
I guess I was asking about the fuse rating. When it comes to power it doesn't touch the ecu except for the flyback on the ecu for the injectors.
I assume the audi factory fuse rating is the proper way to go but i wasn't sure if there was a maximum rating for the flyback wire on the ecu for the injectors?
I use 15A for my injectors (8 of them) and 20A for my coils (again, I have 8) If I used 10A fuses then they didn't last more than a month.
It's been like this for at least 3 years and quite a lot of miles now, so I see nothing wrong with you wanting to stick with factory ratings. Make sure you use the VEMS rating for the ECU itself of course.