Print Page - afterstart enrichment setting

Title: afterstart enrichment setting
Post by: Denmark on February 17, 2010, 11:25:31 PM

Hi All

still trying to go from 1.0.73 to 1.1.64, but i run into tables that i dont know what to put in.

So afterstart enrichment .

-20 202%
0 206%
20 206%
60 206%

This is what the table says now, but dont know if theis is senseble values

Thanks,
Skassa

Title: Re: afterstart enrichment setting
Post by: lugnuts on February 18, 2010, 09:33:22 AM

start much lower, closer to 100%, especially at 60 degrees and higher.
If the engine stalls immediately after starting, this after-start enrichment might need to be raised.

Title: Re: afterstart enrichment setting
Post by: MWfire on February 18, 2010, 01:15:49 PM

i use
-20 220
0 180
40 130
70 100

Title: Re: afterstart enrichment setting
Post by: Denmark on February 18, 2010, 01:31:15 PM

Thanks guys,

i will lower the amount :)

/skassa

VEMS Community Forum

VEMS => Calibration & Mapping => Topic started by: Denmark on February 17, 2010, 11:25:31 PM