We went over this a long time ago and the information i recived on the subject seemed to be wrong as the exact opposite of what i was told worked for me. haha. I'm switching over to 1600 for primaries as im going to be running E85 and i require the extra fuel demand. So the injectors will be matched(1600cc primaries and 1600cc secondaries). I could never figure out the Rate to calculated PW formula. Is there any clarification on this? Also is there a firmware upgrade that is safe for me? I know i have a "special" release that enabled staged injection, i saw note that a later release also included it as well.
Thanks,
The always lost and confused Brendan
Late reply, I know. I just saw this post.
If you can hold out a month or two, the new firmware/tuning software release should completely take care of this situation.
For same size injectors it *should* be 0x20 (in Hex) or 32 decimal for the rate to calculated PW in 1.0.69-1.0.78 firmwares, which IIRC yours is 1.0.74 or close to that.
There was a point where we changed it from a compile time option to a config enabled option, but I don't recall exactly what version that happened at.