Technical > Wiring & Sensors
rev counter input?
dnb:
The ignition channels are called I259. They are selected in the same way as you would a p259 channel.
You will need a pullup resistor.
Tony C:
still no joy,
the car was at the alarm specialists today also,
it has a CAT1 clifford alarm fitted with intelli start,
this runs on ANY set up as it just needs to detect a varying voltage to arm the remote start,
even the clifford could not detect any rpm output from the ecu,
any ideas?
gunni:
Has the ecu been tested by somebody else?
Tony C:
Dave (dnb) repaired the trigger prob for me,
not sure if he tested the tach output though,
Maybe Dave could reply, ;)
paul_f:
--- Quote from: Tony C on November 03, 2009, 05:21:09 am ---let me know if it works when you plug it in this time mate,
i may have a go at taking mine apart,
--- End quote ---
I got mine back today. I'd definately try and open it yourself, Autometer charged me 25$ for fixing and cleaning it but 75$ to post it back! It only cost £7.20 to send it there
Still it is cheaper than getting a new one.
I'll let you know if it works now! I fitted a pull up resistor inside my ECU, it didn't have one originally (although the pads are there)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version