« previous next »
Pages: [1]

Author Topic: N2O Input Switch Channel Settings  (Read 5629 times)

Offline Sprocket

  • Hero Member
  • *****
  • Posts: 867
  • BHP: 29
N2O Input Switch Channel Settings
« on: August 03, 2009, 03:16:24 am »
Firmware 1.0.79

N2O settings

input switch channel number is a decimal number, just to confuse us all :D

Any one know what the decimal number is for input channel 6 and 6i ???

Logged

Offline Sprocket

  • Hero Member
  • *****
  • Posts: 867
  • BHP: 29
Re: N2O Input Switch Channel Settings
« Reply #1 on: August 06, 2009, 06:39:24 pm »
BUMP

Doe anyone know?

Decimal or Hex address for the MCP3208 analog input channel numbers 5, 6 and 7

some one must know as there are a few of these settings used ???
Logged

Offline MWfire

  • Hero Member
  • *****
  • Posts: 721
  • BHP: 35
Re: N2O Input Switch Channel Settings
« Reply #2 on: August 07, 2009, 01:52:07 am »
i use 1.1.47 and input channel is normal to select(ch 1,2...).
tomorrow i'll loock hex nubmer for channel.
Logged

Offline Sprocket

  • Hero Member
  • *****
  • Posts: 867
  • BHP: 29
Re: N2O Input Switch Channel Settings
« Reply #3 on: August 10, 2009, 06:51:27 am »
bumpety bump

 :-\
Logged

Offline MWfire

  • Hero Member
  • *****
  • Posts: 721
  • BHP: 35
Re: N2O Input Switch Channel Settings
« Reply #4 on: August 17, 2009, 05:07:10 pm »
n2o_input   = bits ,    U08,   6,   [0:3], "0","1","2","3","4","5","6","7","0inverted","1inverted","2inverted","3inverted","DISABLED","5inverted","6inverted","old: SCL"
Logged
Pages: [1]
« previous next »