problem geting Boost alternate settings to work

[d00ze]

HI,

Ca18det running fw 1.1.44 alpha.
Boost solenoid is from Vems.hu.

Problem with alternate settings not working.
The Basic boost settings is enabeld and the solenoid is clicking when setting "acuator off to 0", but when I change to Boost alternate settings the solenoid dosn't click.
I have tried change output to other injector and the "acuator OFF below this pressuer (kPa)" is set to 0 to here the solenoid clicking.

Heres my msq file:
http://www.vems.hu/files/MembersPage/MaxLarsson/msq/fw1144alpha_ca18det_788cc_1.7bar.msq

Thanks for the help

//Max Larsson
Stockholm Sweden

[gunni]

Where have you connected the solenoid in?

[d00ze]

The solenoid is connected to "EC36 pin 18" value 32. "injector output" is set to Inj 5 = 32.

[GintsK]

It seems to me that your boost table is mirrored. Normally you need values close to 100 at lower rows and 0 above desired boost.

[d00ze]

The solenoide would buzz even if the tables are inverted when setting the Off below pressure to 0. This dosn't hapen.
Is there something wrong in my settings?
I get the solenoide to buzz under Boost Alternate settings buy selecting Open loop. If i disable MPC3208 the solenoid get silent.

//Max

[GintsK]

Check output channel. Is not used from other function.
Boost alternate should be configured like closed loop.
MC3208 should be disabled. At least in beginning.
MAP target. 0Kpa offset.
Check boost limiting factors: Boost vs rpm and TPS, and EGT and IAT in newer firmwares.
Off pressure below atmospheric at test and normally some kPa above.

Gints

[d00ze]

Tried to move the solenoid output to i259 ch4. The solenoid is only buzzing under Boost Controll Settings and not under Boost alternate. What components are controling the solenoide? I belive this is a hardware error and not some settings in the fw.

[GintsK]

It should be more like fast clicking than buzzing. ?

Why hardware. Your hardware works if solenoid works. You have some other mismatch IMHO.

Gints

[d00ze]

The solenoid is clicking under Boost Alternate setting when set to open loop and MPC3208 it any chanel in the list. if i Set it to disable the solenoid stops clicking. Tried to get the solenoide to work with open loop and seting up PWM boost. The solenoid dosn't bleed the air out so I get WG closed at all time. Im having an external wastegate Tial 38mm.

I had this woring under closed loop before I destroyed the box and got it repaired. Realy anoying.

Pressure connected from turbo to bottom of wg. Then one pressure line goes to the top of WG passing throug the solenoid.