LPG fuel pressure correction

[lost]

KAMUTO / VEMS / MWFIRE , could you share few screen shoots of anytrim/diffamp input configuration for lpg temp / pressure from your config?

[lost]

I have connected pts-01 sensor(it has two same map sensor inside 0-4bar 0-5V (for vacuum and lpg pressure) to JP9 diff amp.

ADC analog CH0 is calculated value from diff amp and it works i would use it for lpg fuel trim later...

analog CH1 is value in volts for lpg pressure and its displayed ok

problem is:

analog CH2 reads 0.0V when disconnected, if i connect 1 Volt wire, it reads 0V

When analog CH1 is connected to  3volt from sensor#1  (reads ok) and then when  i connect 1 Volt from sensor#2 to CH2,  CH1 then jumps (reads) to 5V, if i switch wires, then it reads 0v.

Is there problem with internal pullup?

I have VEMS v3.5 it sholud be like 3.3


Youtube link:
https://youtu.be/r8hH_3in7sU

[lost]

Can anyoone help me out with CH2,  input?

[lost]

Time to resurrect this topic

I never figured it out, my genboard is v3.5 (top picture), should be same as v3.3 (bottom picture, schematic)

I have two 7bar map sensors outputs connected to JP9 one MAP  is on intake vacuum, second MAP is LPG fuel pressure on injector rail (marked yellow on top picture)

And i get this result:
https://www.youtube.com/watch?v=r8hH_3in7sU&feature=youtu.be

How to get it to work ?

[MWfire]

Did you change gain?

[lost]

No, where to change it?


BTW, i wanted to contact you for dyno after sorting gremlins in car and wiering/sensors (old was wrecked-not by me), so i got another crap for 500€ and transfered  VEMS  and LPG in it) i was wondering if you moved out from country like everybody else, and today i read on alfa forum that you tuned 24v tb alfa so please PM your mobile number i lost it.

Its drivable on gas now , and on lpg i need injector settings for barracuda/hana injectors.

[lost]

Plese note that ADC raw is strange, like in video when i connect second wire on JP2.
First i shows 2.2V on ch1, then i connect other input and it shows 0.44V on ch2, And ch1 goes from 2.2V to 5V


And i am using  v3.5, maybe something is different than on v3.8

[lost]

bump on topic...

[lost]

Can anyone help i want to connect two map sensors (same, on on lpg pressure hose, second on vacuum hose) to vems diff amp on vems v3.5.

It also has temp sensor for LPG