VEMS v3.3 with AudiTrigger - how to run Audi V8 ABZ on this?

[guzior]

Hi.
6 months ago I bought VEMS V3.3 with:
primary trigger: VR
secondary trigger: AudiTrigger
He worked with 20V turbo engine. The engine broke down, and I bought the another Audi engine, V8 ABZ. I don't want to modify anything in VEMS board.
What is the simplest way to run this engine on VEMS with my trigger setup?

[GintsK]

Same three sensors?
I have same case, but problem - my customer is 250km away from me. Auditrigger seems working on benchtest. But in real life engine now runs without hall sender...
I use auditrigger divided by 2.
136 teeth on flywheel.

[guzior]

So, when only crank sensor are in use, engine work with wasted spark?

[gunni]

Your crank signal must have a reference in the form of a either one or two missing teeth.
This will allow wasted spark and semi sequential injection.

[GintsK]

In this case it is coil type with reference pin on crank.
Yes it run in wasted spark mode. I hope we will be able to run fully sequential. Car is not tuned jet.

[guzior]

I wire coils as wrote [email protected]:

Assuming that the coils are wired like this:
Coil 1 to EC36-pin35
Coil 2 to EC36-pin33
Coil 3 to EC36-pin34
Coil 4 to EC36-pin36
Coil 5 to EC36-pin11
Coil 6 to EC36-pin12
Coil 7 to EC36-pin24
Coil 8 to EC36-pin10

With a firing order of: 1-5-4-8-6-3-7-2 give a firing order of:
0 - EC36-pin33
1 - EC36-pin24
2 - EC36-pin34
3 - EC36-pin12
4 - EC36-pin10
5 - EC36-pin36
6 - EC36-pin11
7 - EC36-pin35

and, I think at start I'll use only the crank trigger and wasted spark mode. What should I configure in VemsMT? When I run AAN engine on VEMS (2,2T 20V) I have broken hall sensor and similar config (but with 5 coils) and engine work correctly.

And another questions:
I want to charge my V8, so I need some free FET's to control boost controler valve (and other stuff, like idle air control valve)
1. Injector resistance is 16,8ohm. I wire it in pairs. Should I wire any resistor in sequence?
2. I wire injectors like this:
Injector 1 and 4 to Injector1 ch.1 (EC36-7)
Injector 2 and 3 to Injector4 ch.8 (EC36-20)
Injector 5 and 8 to Injector2 ch.2 (EC36-19)
Injector 6 and 7 to Injector3 ch.4 (EC36-8)
Is this correct connections?
How configure VEMS to run that configuration of injectors?