problem after firmware update

[Ellisd]

Is there any update on this?  My gauge still isn't playing ball.  Since it doesn't do the heater count there just isn't any time to upload the old firmware.  The connected to a laptop the gauge seems to be working, as all the values on the laptop screen are right.  It's just nothing shows on the gauge other than the -FU -FFu.

[[email protected]]

I thought the answer was to go back to the 2008 versions.
The release procedure is pants I'm afraid.

[Sambas]

Is there any update on this?  My gauge still isn't playing ball.  Since it doesn't do the heater count there just isn't any time to upload the old firmware.  The connected to a laptop the gauge seems to be working, as all the values on the laptop screen are right.  It's just nothing shows on the gauge other than the -FU -FFu.

Try pressing button long or in megatune put zeros to all boxes in display demo menu (probably you see 165 in two places). You guys are experiensing AIM input that is enabled when not checking the settings after update. S flood always works.

[Ellisd]

Ok i'll give the S flood a try see what happens.