« previous next »
Pages: 1 [2]

Author Topic: Temperature Sensor Configuration  (Read 37755 times)

Offline MWfire

  • Hero Member
  • *****
  • Posts: 721
  • BHP: 35
Re: Temperature Sensor Configuration
« Reply #15 on: February 23, 2009, 06:49:37 pm »
I can make calibration file for your sensor. But you will need to change one resistor(pull up).
Logged

Offline z0tya

  • Sr. Member
  • ****
  • Posts: 252
  • BHP: 11
Re: Temperature Sensor Configuration
« Reply #16 on: February 23, 2009, 07:09:23 pm »
Can i do the pullup outside the vems box? Or just internal.
I don't want to dissasemble the box.
Logged

Offline MWfire

  • Hero Member
  • *****
  • Posts: 721
  • BHP: 35
Re: Temperature Sensor Configuration
« Reply #17 on: February 23, 2009, 09:04:12 pm »
Quote from: z0tya on February 23, 2009, 07:09:23 pm
Can i do the pullup outside the vems box? Or just internal.
I don't want to dissasemble the box.

internal. I can make calibration file for serial vems resistor, but accuracy would be bad.
Or you can buy this sensor (1E)
http://shop.vems.hu/catalog/product_info.php?cPath=1_12&products_id=54&osCsid=a7e20411f9aff684f671964c4a438cfd
Logged

Offline z0tya

  • Sr. Member
  • ****
  • Posts: 252
  • BHP: 11
Re: Temperature Sensor Configuration
« Reply #18 on: February 23, 2009, 09:22:13 pm »
okay, thanks

i will use some better sensor than the o.e.
Logged

Offline rob@vems.co.uk

  • Hero Member
  • *****
  • Posts: 3115
  • BHP: 49
    • VEMS Forum
Re: Temperature Sensor Configuration
« Reply #19 on: February 23, 2009, 09:44:51 pm »
Those early Ford ones seemed to be similar to the sensors that are used for the dashboard temp gauge.
The later Fords seemed to use thermocouples!

Get a nice Bosch style one.
Logged
Pages: 1 [2]
« previous next »