Audi RS2

[AVP]

Update.

after a few runs yesterday on the setting of the WI that i have with the snow perfomance controller, i saw that mixture was getting closer to 0.79 and 0.78 ever so slightly.

IATs and EGTs where also slightly lower.

SO after i fit the safe injection controller and wire that to the config switch so that it switches configs as safety in case of low flow, i will adjust the fuelling a bit and give some more timing (little by little) to see if i get any gains.

[DevInAz]

What is this virtual dyno software you are using? maybe I didn't look back in your thread far enough.

[AVP]

its a little excel that when you input time vs rpm on 3d or 4th gear and also input the gear ratio/weight/frontal area of car/tyres it can generate a power/torque figure for each run you do, so long as you do a proper full throttle 3d or 4th gear pull on a level plain road.