Strange PW raise on ignition on while not cranking the engine

[gox]

I noticed it few months ago, but unit was home assembled sl i didnt bother much...but few daya igo i installed one more ecu that came factory assembled. If you stay for ignition on for a while, like 30sex or more PW goes up to arround 150-200, i didnt tryed to start the engine, but of you just reset the ecu it goes to normal cranking pw. One more thing i suspect is option to enable lambda with no rpm if this is disabled, pw stays normal. I didnt used ego correction, it wasnt “disabled” but rich and lean limit was set to 0%.
Fw on last unit is 1.2.11 and the earlier one is something arround 1.2.36.

Anyone noticed this?

[Kamuto]

I noticed it few months ago, but unit was home assembled sl i didnt bother much...but few daya igo i installed one more ecu that came factory assembled. If you stay for ignition on for a while, like 30sex or more PW goes up to arround 150-200, i didnt tryed to start the engine, but of you just reset the ecu it goes to normal cranking pw. One more thing i suspect is option to enable lambda with no rpm if this is disabled, pw stays normal. I didnt used ego correction, it wasnt “disabled” but rich and lean limit was set to 0%.
Fw on last unit is 1.2.11 and the earlier one is something arround 1.2.36.

Anyone noticed this?

it's normal.

[gox]

Why? :-)

[Kamuto]

Why? :-)

is it opening injectors on not working engine? no, so why you worry about that?

[gox]

I am just curious to know how stuff works...

[Kamuto]

I am just curious to know how stuff works...

if you would fill wiki page about that, somebody from devs would answer your question :)

[jrussell]

Pulsewidth shows %O2 after a while when the O2 sensor is set to heat on startup and the engine isn't running. It should be ~19-21 on the gauge (19-21% O2 in the air) depending on how "dirty" the exhaust is around the sensor. If it hasn't run for a long time, it should be 20.9 since that's the % of O2 in free air. Don't get too concerned if it's not super close to that, it's not very accurate reading "free air" in an exhaust pipe.