Technical > Wiring & Sensors

Wideband input stopped working, any ideas?

(1/2) > >>

DButters:
Hi all,
I have had my VEMS unit running for over 6 months now, and noticed that some time in the last 2 weeks the wideband reading has become stuck at 14.2 (or similar base value depending on calibration values I set).
The only thing I changed in that time was to add a tacho output on one of the misc channels. I measured all voltages at the sensor according to the user guide and they match exactly, and the sensor heater is working.

Any likely places to look for a problem here? Any more info needed to help diagnose the problem?

Thanks in advance!

GintsK:
And what about O2 sensor itself?

DButters:
I will have to pull out my old AFR gauge to double check, but it is less than 2 months old and the vehicle has just been dyno tuned so im not pouring fuel into it :). I will update that status, but in the mean time is there any way to test a reading without a sensor? no resistor / voltage divider combination we can use to fake any reading?

Bat:
Hi,
Check the 12v feed to the sensor.
Cheers,
Gavin :)

Denmark:
I have had 2 sensors that have failed within 6month, on 2 different cars, one was showing values all over the place, and shifting fast, and the other was just showing lambda 2.67 all the time,
Both was working great with new sensors


/Skassa

Navigation

[0] Message Index

[#] Next page