1.1.44 Config for Bosch Ignition Module

[Arvid]

Hi!

 Can I use the 1.1.44 with simple trigger? 2 teeth hall trigger, plus hall trigger camsynk?

Did quick test and it should be ok. c004 signal-> coiltype, No. teeth=4, triggertooth=0, another triggertooth=1, toothwheel width=180, secondary trigger=25 and reftooth table=[0,3,2,1]

 Thank you! I've Bosch motorsport ignition modules, so I'm not entirely sure how I set up reftooth table. =[0,3]

[GintsK]

No. [0,3,2,1] because there is 4 teeth between cam signals.

Repeat desired output in  ignition output table twice, something like:

ignition outputs in use 03...00

0
1
0
1

[Arvid]

No. [0,3,2,1] because there is 4 teeth between cam signals.

Repeat desired output in  ignition output table twice, something like:

ignition outputs in use 03...00

0
1
0
1

Great! Think I understand a little more now :-) The car started without any problem.