News:

When asking for technical help at the very least let us know the version of firmware you are running.
Cliff's Calibration (Mapping) Guide is a MUST READ: http://www.vemssupport.com/forum/index.php/topic,97.0.html

Main Menu

VEMS ETC Setup

Started by Brk97, June 28, 2018, 11:21:46 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Brk97

June 28, 2018, 11:21:46 AM
I've ordered an ETC Bridge Driver from the VEMS Online shop yesterday. (Order #14529) How can i install the ETC module onto the VEMS ECU ? I'd like to install the PWM pin to the OC0 pin, i already know that. But i don't know where to install the ETC DC motor pins.

Thank You in advance...

Brk97

#1
June 28, 2018, 11:26:52 AM

jrussell

#2
July 27, 2018, 03:26:29 AM
Only OC0 and gnd are needed from the ecu on the 6 pin connector. The etc motor is connected to the 10 pin.
VEMS USA - Located in beautiful Burlington, Vermont
1988 RX7 Turbo
Print
Go Up Pages1
User actions