Fault in documentation?

[Rak]

i been looking analog channels from board.

Noticed that in diagram MCP3208CISL channels are numbered 8-3, ch8 beeing up right corner.

http://www.vems.hu/files/genboardv3/v3.3/v33_sch.pdf

But, when i am looking my board, ec18 pin 12, wich is ch7 in pin out, connects that corner spot?

Am i missing something?

Edit: And bottom side on my board says v3.4?

[Rak]

I was missing that channel numbering in vemstune starts from 0  :-[

I think it would clarify things if the numbering was the same.