Technical > Wiring & Sensors
Impreza newagde Vems frontplate
(1/1)
Denmark:
I have just made this, for the weekends Vems challenge ;)
This is for a bugeye WRX..
/Skassa
Denmark:
And then.. :)
gunni:
What does the wiring look on the inside?
Denmark:
The Wiring is just made as short as possible, and then it goes to the print, like the Vems AMP connector would have done..
The wires is then glued, when the print is all tested in the car
I will take a pic when i have made the final wires,
/Skassa
Denmark:
this is before the hotmelt
Just another impreza Vems made, going in a car tomorrow :)
/Skassa
Navigation
[0] Message Index
Go to full version