What am i doing wrong here...?

[gox]

I installed the MSD GM coils for wastespark on my E30 327i and after some time i finally set them to work,but  spark plug gets flooded on cyl3 2-3sec after engine starts...
I have spark on all 3 coils.
This is how are they wired:

EC36 Pin11 (Ign Ch. 40) - Cyl 1&6
EC36 Pin36 (Ign Ch. 30) - Cyl 5&2
EC36 Pin33 (Ign Ch. 10) - Cyl 3&4

In my mega tune it looks like this:
05...00

0     1
1     3
2     4
3     1
4     3
5     4

I`m using semi-sequential fuel injection and while i was on stock coil and distributor everything worked fine...

Since cyl 3&4 are on the same coil,cyl 4 is working absolutely fine...

I forgot to download my config and tables,since it read from 05 to 00 and in h[2] there are 7 numbers,are those last two (or first two since it read backwards) important? I`m using 1.0.73 firmware
My h[2] looks like this:

h[2] = 01 03 04 01 03 04 03 00

[[email protected]]

Check that the injector FET on 3 is not being turned on by another feature (such at Idle, Boost, Misc trigger etc.)
It might be worth using a different FET channel for 3 just to see if the FET is dead and has blown open.

Rob

[mattias]

You must only use "2..0" from the ignition table.

Can't really say much more other than what Rob just said, but I figure it's unlikely that you blew an injector FET between then and now - the coils are the only change right?

[gox]

I switched cyl3 to diffrent fet and its all working fine,and i`m using 5..0...?!

The coils are the only change,yes i dont know when fet died...but never mind know...its all working very nice,i`m using 2.0ms dwell and the car now feels a lot smoother then with stock coil and distributor....
Did some tuning last night and i think its time to set some AE :)


Tnx guys