R85 and R86 Analog Ch6 and Ch7 Input Pull-up

[lugnuts]

For example setting up Launch Control... Is there any difference or advantage between the User Guide way:
http://www.vems.co.uk/VEMSUserManual/ConnectingAnalogInput.png

And using the on-board resistor R85 or R86:
http://www.vems.hu/wiki/index.php?page=MembersPage%2FHansK%2FLaunchControlAndShiftCut

... for the 2700 Ohm pull-up?

[[email protected]]

If it effectively makes the circuit in the same way as the schematic then there shouldn't be a problem.  The way shown in the UserGuide is for assembled units.

[Denmark]

I would like to know if any of you have wired up both a clutchswitch and a second switch for launchcontrol, and how does it work if?

Cant there just be a clutch switch, that is used for both launch and flatshift, thinking that whenever the clutch is pressed the launch and flat is enabled, or will htat not work?


Thanks,
SKassa