Technical > Wiring & Sensors

R85 and R86 Analog Ch6 and Ch7 Input Pull-up

(1/1)

lugnuts:
For example setting up Launch Control... Is there any difference or advantage between the User Guide way:
http://www.vems.co.uk/VEMSUserManual/ConnectingAnalogInput.png

And using the on-board resistor R85 or R86:
http://www.vems.hu/wiki/index.php?page=MembersPage%2FHansK%2FLaunchControlAndShiftCut

... for the 2700 Ohm pull-up?

rob@vems.co.uk:
If it effectively makes the circuit in the same way as the schematic then there shouldn't be a problem.  The way shown in the UserGuide is for assembled units.

Denmark:
I would like to know if any of you have wired up both a clutchswitch and a second switch for launchcontrol, and how does it work if?

Cant there just be a clutch switch, that is used for both launch and flatshift, thinking that whenever the clutch is pressed the launch and flat is enabled, or will htat not work?


Thanks,
SKassa

Navigation

[0] Message Index