Technical > Wiring & Sensors
Stock AE86 Rev counter
Denmark:
Yep ,its indeed the black with orangestribe,
On mine i found the wire in the bulkhead plug,
but i never got it working great,
Mine would work fine up to around 4krpm, and it would then just fall to zero again,
That could probbely had been fixed pretty easy, but i never got around to do it.
It did not bother me much ,as after 4krpm i better hold on to the steering wheel, when it broke traction, pretty easyly ;D
http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassa
/Skassa
Will:
Did you use any pullup resistors or just straight from vems to the black/orange wire?
rob@vems.co.uk:
VEMS doesnt kick out a voltage, so the pull-up will be needed - if its enough of a voltage, personally I think its worth driving the tacho from the negative wire on one of your coils.
Will:
Will give that a try then, atleast I think I have the right dash wire.
Will:
The diode method doesn't work, but 12v direct on wire works, so how do I do the pull up resistor or do i just connect 12v the taco/ecu wire?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version