Opel C20XE crankshaft sensor

[kkh]

Hi

I got a crankshaft sensor (6PU 009 146-151) with 3 wires that was bourght fore a early C20XE, dos any one know if this is a Hall-sensor?

Thanks
Hans

[MWfire]

It is vr sensor. Third wire is shild. Red wire is -, black wire is +.

[kkh]

It is vr sensor. Third wire is shild. Red wire is -, black wire is +.

Thanks alot, but I don't have the original wire-harness so I can't see which one is red and black.
Any ide which one is pin-1,2,3?

[rob@vems.co.uk]

take measurements of the resistances across the pins.  Pin3 will be the sheild so it will give no reading across the other pins.

[kkh]

take measurements of the resistances across the pins.  Pin3 will be the sheild so it will give no reading across the other pins.

Yes I see but dosent it mather which one I use as + and - (pin 1-2)?

[MWfire]

It's matter. If you connect opposite you couldn't read rpm.
1pin +
2pin -
3pin shild

[kkh]

It's matter. If you connect opposite you couldn't read rpm.
1pin +
2pin -
3pin shild

Thanks alot.

I'll post my project when I get the 36-1 and waste-spark installed.