Adding 2nd EGT to assembled VEMS

[MTRacing]

I inadvertantly ordered my pre-assembled VEMS configured with only one EGT on-board and would like to have two. :(

Is this as simple as adding a second AD597AR chip or are other parts needed? I already have two thermocouples.

Any guidance out there regarding the steps to add the second before I dig into this?

Thanks!

Mike

[[email protected]]

IIRC the AD597AR has two inputs, so its down to getting the second channel connected with k-type wire.

[gunni]

According to the build sheet you install another chip on the flip side,