what i want to do

[[email protected]]

Thats it in a nutshell, as long as the software and hardware configuration matches up you can use which ever channel you want.

Schematics are do-able, I'll need some information of what's what though :D

[richard s]

let me know what you need
cheers

[[email protected]]

To be honest I could ask you the same question.

Lets start with the sensors:

TPS.

Coolant.

Air temp.

I'll need the pins and resistance measurements (and rough temperature when measured) to make a start.

Rob

[richard s]

were off to a flying start as i dont have any of the sensors yet but i will be using the ones from the vems site (unsure which tps at moment)
also i will be using the gt101 hall sensor i think that is all i need sensor wise
could you put prices for above sensors up
as for pins i take it you mean what sensor is wired to on ec36  also how do i find resistance measurments
and i nearly forgot egt sensor
cheers

[richard s]

back to the schematics the tps sensor i think i will be using a ford one i will at some point be buying the wb02 kit also using a single coil
what other info do you need
cheers

[[email protected]]

If a Ford one fits then its all good, they're all pretty much of a muchness +5v in one pin, Gnd at the other and the wiper gives a voltage depending on its position.
The VEMS has the WBO2 controller built-in and the Gauge does not integrate with the ECU, so you dont need anything other than the WBO2 sensor.

[richard s]

cool is that everything you need to be able to do schematics
cheers