Audi RS2 P'n'P

[billman]

Hi from Germany,

i am about to install VEMS PNP on my RS2 and had the following problems yesterday. It supposed to have a 16x14 firmware but still become a message that the controller has 12x12.

Appart from it on the 1.1.27Beta2 package the 16x14 firmware upgrade is not present (it says that i had a bad Package).
t with
Any thoughts on this?

Is there any RS2 files (stock HW setup) so i can start with?

regards,

Vasilis

[[email protected]]

I don't know anything about the Audi setup, but I do know that 12x12 is the officially supported setup, and the 16x14 is very much experimental.  Personally I've not found a reason to use anything other than 12x12.

[billman]

As i tryied to install the other Firmware it started to tick all the relais. Now it doesnt even start with the stock ECU. Must search to see what failed.

I am going to use 12x12 also. Lets see.

[[email protected]]

If you changed the polarity of the flywheel sensor and didnt put it back to how it was originally, then that would stop it seeing the right flywheel signals.

Rob

[billman]

YUUUUUUUUUUUUUPIIIIIIIIIIIIIIIIIIIIIIIII

It started today. Yesterday was my first try. Today after 2 hours on the car it started (still without EGT and WB).

Very nice. Indeed PnP. Thanks guys over here and on the VEMS WIKI-Group