Technical > Wiring & Sensors
Finally finished the prototype MY93 to 96 Subaru plug and play adaptor
Denmark:
Okay,
I will put a wire a cross the grounds, then :)
Thanks,
I did the last time acutully burn the p259 chip, so that could be why ::)
/Skassa
rob@vems.co.uk:
Its easily done
Denmark:
Yep.
Did you see that you in the manual writes that it´s EC36 pin13 that is for a VR sensor, but it´s EC18 pin 12.
No i just need the time to plug it in, to see if i can get at trigger signal..
/Skassa
Denmark:
Dnb,
Did you have any luck with getting the engine finished, and if.
Have you tryed ,if the trigger setup is working?
Now that i have put a wire across the ground wires,
I will today try to plug mine in, the problem is that i dont got a 12v supply,so i have to put it into the car, to test.
and i dont even know what firmware that comes with my board(number1484).
/Skassa
rob@vems.co.uk:
It will probably be something around 1.0.3x to 1.0.5x
As for a 12v power supply... I use a spare drive power connector inside my PC the VEMS only draws a few milliamps so you can have fun testing it on the bench.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version