Technical > Wiring & Sensors

Finally finished the prototype MY93 to 96 Subaru plug and play adaptor

<< < (3/6) > >>

Denmark:
Okay,

I did not check the wirediagram, i just looked at the pinout,
are you using the stepper to run the ignition module, or runnnig it some other way?

Thanks,
Skassa

dnb:
I'm using both the water pump and fan outputs for the radiator fans, so I'll be using IGBTs to drive the coils.  (This will be done directly if the ignitor unit gives me any problems)

The secondary reason for this is that my v5 RA has a 4 wire stepper, so if that ever gets VEMSed, it'll need the stepper driver to be a stepper!

 

Denmark:
I have today been working a bit on this wiring on my vems board,mounting another lm1815 chip to make the second vr input trigger.
So it now got primery and secondery trigger made to VR

I just saw this..



As you can see the tps voltage goes from high to low, and not the otherway around,
that dont seem to be suported in megatune,
So do i just switch + and - on the tps??

I can also see that i have a lot more wiring on the oe plugs, then you do??
I dont suppose you are going to run it all with VEMS


Regards,
Skassa

rob@vems.co.uk:
VEMS will take TPS going from high to low or low to high.

A lot of the existing wiring is for things like MAF, Lambda, A/C, and so on.

Denmark:
Okay, then it´s no problem with the tps.

regarding the lesser wiring, i can see it says, before ground wires, which there is lots off :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page