News:

When asking for technical help at the very least let us know the version of firmware you are running.
Cliff's Calibration (Mapping) Guide is a MUST READ: http://www.vemssupport.com/forum/index.php/topic,97.0.html

Main Menu

HELP!!!no reaction of board after AREF mod

Started by Timmo6, February 03, 2008, 04:20:11 PM

Previous topic - Next topic

Timmo6

nono.....
I did attach the 5 ground pins (26,5,32,21,22)
but the strange thing is that when the connector is not connected I measure +12v at pin25 and good grounds at the ground pins, but when connected the voltage drops to 1,48v????

[email protected]

So when powered the voltage gets pulled down.

Fault looks to be on the board then

Rob

Timmo6

yeah but when I made the setup on the bench without the wiring in the car the board was OK and measured +5v at the output???
I will check this afternoon again in the car with only the ground pins and the +12v connected.
Tim

Timmo6

PROBLEM SOLVED ;D

The +12v feed from the main relay in the car lost some voltage when connected to vems.
This is the wire that is used as the +12v feed for the original ecu. This is very strange.
I changed this wire for another +12v feed when ignition is on and everything is OK now.

Thank you very much for the quick and acurate help Rob! ;)
Tim