MAT Sensor Length

[MTRacing]

Greetings!

I'm attempting to find a MAT sensor long enough to use an existing 3/8" npt port on my Edelbrock Victor E manifold.  The problem is this area has 1 1/2" :o of material from the outside surface to the inside of the port! I just received an MSD 2320 MAT sensor and it measures 1 3/8" from the tip to the underside of the hex nut leaving the sensor tip shrouded in the hole.  This sensor would need to be at least 1/2" longer to extend it properly into the airflow. 

Can anyone verify the length of the VEMS Webshop MAT sensor from the sensor tip to the underside of the hex nut? I believe that I can find an adapter to convert the M14 threads on the VEMS sensor to 3/8" NPT.

Alternatively, does anyone know of a good source to compare the specs and physical measurements of various sensors?

Any help would be appreciated as finding the right sensor might prevent removing the intake for modifications!

Thanks!

[[email protected]]

I've measured the one we use and its 1.5" long.

[MTRacing]

Thanks Rob!

Any ideas about an on-line source that has specs on other MAT sensors?

[[email protected]]

I'm afraid that I don't.  At the end of the day the sensor is just a thermistor, if you took some externally threaded tube, mounted a radial thermistor http://shop.vems.hu/catalog/product_info.php?cPath=1_12&products_id=54&osCsid=09e36145bad4b00a9d856e1266895ab4 so that its body was proud of the end and filled the tube with epoxy, you'd have a sensor of what ever length you'd like.

Rob