I've got the Merc MAT sensor to install into my plenum this week.
I think its a M14 standard thread, could anyone confirm, or is it M14 fine? Or maybe its not M14 at all
My local tool shop only had up to M12 so I couldnt try and confirm the thread type.
Also I was thinking of mounting it just behind the throttle butterfly, there hope theres enough room (height wise) I assume there isnt a reason not to use this placement, its nice and flat you see
About half way between the ECCS badge and the throttle body is my plan.
I'll be taken the plenum off to drill it, so I could go in from the side if needed.