I upgraded from 1.2.11 to 1.2.30 to add lsu 4.9, soldered in the resistor got 4.9v, changed settings to lsu 4.9 and did free air calibration.
The problem during live analyzer and autotuning is that if lets say the VE cell says 60, lambda target is 1.01, actual reading is 1.09, autotune will then add 1-or2 the the cell goes green and it says TUNED, but now it might be reading 1.07 instead and still to lean. So i discovered that if i keep the dot at that particular cell for longer, lets say half a minute, it will add more and more fuel until its ok. But it says TUNED long before it is ok.
EGO correction was disabled.
And even if i make all the VE cells to rich, it doesnt stop pulling fuel at the correcet lambda target, it goes beyond until lean area?
Is there anything else messing with my lambda target or is this normal behaviour?
