Brake pressure sensor channel recommendation

[se7ensport]

Hi

I'm using VEMS to record lap data, ideally I want to track braking points along with relative pressure i.e. actual PSI numbers aren't important, but 0-100% is very useful.

I've found a 3 pin sensor used on VW stability control systems that looks ideal (pin 1 +, pin 2 -, pin 3 signal), is there a recommended channel that the signal volts would be best returned to? I don't have oil, fuel or boost pressure in use - would one of these be suitable without the data forming part of another calculation and corrupting VE or spark?


Thanks
Alex

[gunni]

You can use any non pulled up channel and then use the analog input calibration help to make it scale properly.