« previous next »
Pages: [1]

Author Topic: EDIS CONVERSION  (Read 6995 times)

Offline chencho16000

  • Jr. Member
  • **
  • Posts: 76
  • BHP: 2
  • rally driver
EDIS CONVERSION
« on: November 04, 2007, 12:14:23 pm »
ITS POSIBLE CONVERT FORD EDIS SYSTEM IN SEQUENCIAL?
ADDING COIL DISTRIBUTOR ?
ADDING 1 COIL 1 CYLINDER?
ANY SUGGESTION?

THANKS.
Logged

Offline rob@vems.co.uk

  • Hero Member
  • *****
  • Posts: 3115
  • BHP: 49
    • VEMS Forum
Re: EDIS CONVERSION
« Reply #1 on: November 04, 2007, 02:19:01 pm »
If you're using VEMS theres no need to use the Ford EDIS module at all.  To make things fully sequential you're going to need a cam position sensor.
Logged

Offline chencho16000

  • Jr. Member
  • **
  • Posts: 76
  • BHP: 2
  • rally driver
Re: EDIS CONVERSION
« Reply #2 on: November 04, 2007, 08:19:31 pm »
it can serve a distributor with hall sensor conect a simple coil?
as it would be the connections scheme?

Thanks.
Logged

Offline rob@vems.co.uk

  • Hero Member
  • *****
  • Posts: 3115
  • BHP: 49
    • VEMS Forum
Re: EDIS CONVERSION
« Reply #3 on: November 04, 2007, 09:41:23 pm »
If the distributor has only one tooth per cam revolution.
Why are you using EDIS?
Logged
Pages: [1]
« previous next »