quicky: how to remove pin

[miniminor63]

Hi

I put a pin into the wrong slot in my econoseal 36. How do I get it out again without breaking anything?

Thanks

[hilly]

There is a little barb (part of the black plastic of the Eccon connector) which engages as the metal contact is pushed in and holds the wire in place.

You need to insert a small flat blade screw driver from the from the front of the connector, lift up the barb and then pull the wire out from the back, dead simple

Hilly

[lost]

White plastic cover wont go in econoseal, it sticks out 2mm, on ec18 it fits without problem.

Any ideas before i pull every ec36 wire out 

[lugnuts]

you have the wire end pushed in too far in the terminal, try not to go much past the metal crimp area

[lost]

 

Thanks

[rob@vems.co.uk]

I wrote something about pin removal here:
http://www.vems.co.uk/VEMSSchematics/1+2JZLoomGuide07May2008.pdf