VR to HALL

[beny1989]

Hello
I have a problem with plugging the converter VR to HALL:
https://shop.vems.hu/catalog/hall-p-162.html

How do I connect to my VR signal is converted into the Hall signal as required by the ECU. It is the trigger wheel signal.
Sorry for bad English

[Mads Lund]

Hi

Do your Vems have primary trigges as Hall ? in case, then I think it's better to modify your board to run VR, and connect the sensor directly to the ECU.

Guide to check and perhaps modify is here http://www.vems.hu/wiki/?page=GenBoard%2FManual%2FInputTriggerHardWare

Please post some similar pictures from your own board, and we can verify you hardware setup.

Br Mads

[beny1989]

I have an old Megasquirt which only supports Hall.

[Mads Lund]

It can be, that you need a pull-up resistor between +5v and the hall input.

[beny1989]

Hi engine now running with this converter but rev up just to 1500 rpm, wiht 1kohm resistor on Vr sensor wire it rev up to 3500 but if I add on more resistor engine dies. Can you help me with those resistors? thanx