v3.8 board sec trigger conversion hall>vr type

[Sam8888]

On the link it says use Hall on both.

"Leaving the 360 impulse disk - implementation works well (slightly above 10000 RPM on bench)

the 4 (or 6) window pulse connected to primary-trigger HALL input
the 360 pulse signal connected to sectrig HALL input (without any hardware divider !)
lower filtering capacitor must be used of course, so mention "sectrig=HALL,Nissan360pulse" in the order comment
See "Nissan special settings" in [VemsTune Help] on how to measure the length of the longest primary trigger window (if you don't know, or want to verify)"

[Kamuto]

On the link it says use Hall on both.

"Leaving the 360 impulse disk - implementation works well (slightly above 10000 RPM on bench)

the 4 (or 6) window pulse connected to primary-trigger HALL input
the 360 pulse signal connected to sectrig HALL input (without any hardware divider !)
lower filtering capacitor must be used of course, so mention "sectrig=HALL,Nissan360pulse" in the order comment
See "Nissan special settings" in [VemsTune Help] on how to measure the length of the longest primary trigger window (if you don't know, or want to verify)"

yes hall both

[sandokan]

Thanks problem solved car works