« previous next »
Pages: [1]

Author Topic: Problem with 0-150psi sensor calibration  (Read 7385 times)

Offline TC-Tuned

  • Jr. Member
  • **
  • Posts: 7
  • BHP: 0
Problem with 0-150psi sensor calibration
« on: September 10, 2016, 04:14:55 pm »
I have a 0-150psi 0.5v to 4.5 pressure transducer but i can't get to display correct info on oil or fuel pressure, when the car is not running it says it has -9 psi fuel pressure

these are the settings

Logged

Offline Kamuto

  • Hero Member
  • *****
  • Posts: 814
  • BHP: 19
Re: Problem with 0-150psi sensor calibration
« Reply #1 on: September 10, 2016, 04:25:29 pm »
that means min voltage is not 0.5 :))
Logged
Vems installer in Lithuania
valdas.sunokas@gmail.com

Offline gunni

  • Hero Member
  • *****
  • Posts: 1492
  • BHP: 37
Re: Problem with 0-150psi sensor calibration
« Reply #2 on: September 10, 2016, 10:28:24 pm »
Kamuto can you explain your answer? Its not very helpful
Logged

Offline Kamuto

  • Hero Member
  • *****
  • Posts: 814
  • BHP: 19
Re: Problem with 0-150psi sensor calibration
« Reply #3 on: September 11, 2016, 12:02:22 am »
Quote from: gunni on September 10, 2016, 10:28:24 pm
Kamuto can you explain your answer? Its not very helpful
it means with no pressure, when engine is not running sensor is giving not 0.5v but maybe 0.2v or similar ;)
Logged
Vems installer in Lithuania
valdas.sunokas@gmail.com

Offline gunni

  • Hero Member
  • *****
  • Posts: 1492
  • BHP: 37
Re: Problem with 0-150psi sensor calibration
« Reply #4 on: September 13, 2016, 01:45:20 pm »
Many sensors have a reading range of 0.5-4.5v

0 = 0psi
4.5v = X psi
Logged

Offline Wolf_Tm

  • Jr. Member
  • **
  • Posts: 86
  • BHP: 0
Re: Problem with 0-150psi sensor calibration
« Reply #5 on: December 28, 2016, 06:50:50 pm »
Quote from: TC-Tuned on September 10, 2016, 04:14:55 pm
I have a 0-150psi 0.5v to 4.5 pressure transducer but i can't get to display correct info on oil or fuel pressure, when the car is not running it says it has -9 psi fuel pressure

these are the settings




Did you solve your issue?
Was that a Bosch 2 wire pressure sensor?
Logged
Pages: [1]
« previous next »