« previous next »
Pages: [1]

Author Topic: VEMS ETC Setup  (Read 4403 times)

Offline Brk97

  • Jr. Member
  • **
  • Posts: 2
  • BHP: 0
VEMS ETC Setup
« on: June 28, 2018, 11:21:46 am »
I've ordered an ETC Bridge Driver from the VEMS Online shop yesterday. (Order #14529) How can i install the ETC module onto the VEMS ECU ? I'd like to install the PWM pin to the OC0 pin, i already know that. But i don't know where to install the ETC DC motor pins.

Thank You in advance...
Logged

Offline Brk97

  • Jr. Member
  • **
  • Posts: 2
  • BHP: 0
Re: VEMS ETC Setup
« Reply #1 on: June 28, 2018, 11:26:52 am »
Logged

Offline jrussell

  • VEMS USA
  • Administrator
  • Full Member
  • *****
  • Posts: 224
  • BHP: 15
    • VEMS USA
Re: VEMS ETC Setup
« Reply #2 on: July 27, 2018, 03:26:29 am »
Only OC0 and gnd are needed from the ecu on the 6 pin connector. The etc motor is connected to the 10 pin.
Logged
VEMS USA - Located in beautiful Burlington, Vermont
1988 RX7 Turbo
Pages: [1]
« previous next »