Author Topic: Waterpump input sensor option?  (Read 3655 times)

Offline nmerrill

  • Jr. Member
  • **
  • Posts: 19
  • BHP: 0
Waterpump input sensor option?
« on: May 21, 2020, 02:56:23 pm »
I'm setting up a trans oil circulation pump that I would like the ECU to control via a temp sensor.  It seems that the best option for this is to use the Waterpump output.
However, in VEMSTUNE 1.5.57 it appears that I cannot select the input sensor used - that option is not available, like the help section indicates.  I'm guessing that the waterpump is linked to the coolant temp, but not sure.

I'm running firmware 1.2.31

Can I change the sensor that the waterpump output is sensing?  I have a custom sensor curve, and am reading correct trans temp at ADC ch. 2.


Offline jrussell

  • VEMS USA
  • Administrator
  • Full Member
  • *****
  • Posts: 224
  • BHP: 15
    • VEMS USA
Re: Waterpump input sensor option?
« Reply #1 on: May 21, 2020, 06:47:23 pm »
If you upgrade to 1.2.38 you can set MCP3208 ch. 2 to radiator outlet temperature and use that to control the water pump. I haven't tested thoroughly, but I think that's completely separate from the CLT, so should be safe to use.
VEMS USA - Located in beautiful Burlington, Vermont
1988 RX7 Turbo

Offline nmerrill

  • Jr. Member
  • **
  • Posts: 19
  • BHP: 0
Re: Waterpump input sensor option?
« Reply #2 on: May 21, 2020, 07:23:51 pm »
Ahh, I see that in the firmware changes now- thanks for the tip!