« previous next »
Pages: [1]

Author Topic: Adding third trigger input ( SDA )  (Read 4279 times)

Offline mattias

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1075
  • BHP: 41
    • Sävar Turbo Site
Adding third trigger input ( SDA )
« on: September 02, 2015, 10:37:38 pm »
Hi!

Was wondering how to interpret the text below from this page : http://vems.hu/vt/help/v3/v3_camshaft_angle_control.html

Quote
The third trigger is a processor input pin without any protection.
To set it up, use Pull-up resistor, a 10k protection resistor, and protection Diode, and a 22nF capacitor (min 10nF) between processor pin and GND.

Firstly : The SDA input already has 4.96 Volts on it with nothing connected. Does it need a stronger pull-up? What size resistor must I add towards +5V ?
No work bench to test the strength of the pull-up, was hoping for quick/easy answers.

Secondly : I assume the 10k protection resistor connects to SDA pin and sits in series with diode (1N4007, stripe towards +5V ?) ?


Logged
Pages: [1]
« previous next »