Hello,
It is my first post so I introduce myslef
I'm from Poland and actualy I upgrade my DU Espero (C20LE, TB2531, 240hp) to stage II (C20LE + 16V Head, GT28RS, Water Injection, VEMS, want to achieve 330-340hp ). I've just bought vems and I start to make car wiring.
I have one question that I can't answer by myslef and I can't find any noto in Vems Wiki.
Wehere should be shield of Knock Sensor and VR canks sensor (60-20 toothed wheel) connected ?
I want to use ground paths the same as in orginal ECU (there is shitty delco ecu with no knock detecion, and distributor),
but I want to increase the diameter of some ground wires (the common ECU ground is only 1.5mm).
Knock and vr sensor have two wires + shield. On of wire is singnal wire, second is connected to ECU sensro groun.
Weher should be connected shield ? To common ground, sensor ground, somewhere else ?
For example in C20XE Opel Engine (Motronic) there are separet ECU pins for shileds.
Thank you very much for help. I'm pretty sure that this is no last my post here
Jadzwin