New primary trigger errors on Duratec

[se7ensport]

Engine had been running for the best part of two years without trigger errors that I am aware of.

In the last couple of weeks I have installed a second trigger and wiring.... unfortunately I am now getting primary trigger errors, vems log and trigger log:
http://vems.hu/vemstune/sharingcenter/reports.php?cmd=view&key=YoyaXv



Rolling back to primary only still gives errors and is almost impossible to start:

http://vems.hu/vemstune/sharingcenter/reports.php?cmd=view&key=kYcQrp



Before I rip out the existing wiring, plug and sensor to run a new set is there anything the logs hint at as I'm working on the basis that it must be a bloody coincidence that I likely disturbed a dodgy connection while adding the cam sensor or the crank sensor has just decided to pack up.

EDIT: VR sensors for both Cam (pin 1 to EC36-13 and pin 2 + shield to earth) and Crank (pin 1 to EC36-27 and pin 2 + shield to earth).